We use cookies to ensure that we give you the best experience on our website. If you continue without changing your settings, we'll assume that you are happy to receive all cookies on the Bowers & Wilkins website. However, if you would like to, you can change your cookie settings at any time.


B&W midrange driver, with kevlar and anti-resonance plug

Our Kevlar® cone bass/midrange driver is renowned for its ability to deliver clarity and detail at mid frequencies. New to the PM1, though, is the Anti-Resonance Plug at the centre.

Impulse response of a PM1 bass/midrange driver fitted with a fixed bullet (blue) and the new Anti-Resonance Plug (green).

Unlike the majority of dust caps, this mushroom-shaped device is a tight fit inside the voice coil bobbin.The stiffness and resistance properties of the EVA polymer are adjusted to damp down the tendency of the coil former to go out of round under the influence of cone break-up modes.

Damp the flexing of the bobbin and you in turn reduce the cone break-up, leading to a smoother response at the upper frequencies of the driver and a commensurate reduction in sound overhang.

Impulse response of a PM1 bass/midrange driver fitted with a standard dust cap (red) and the new Anti-Resonance Plug (green).

As bass drivers get smaller, it becomes increasingly important to prevent residual noise from turbulence as air is forced through the magnet system from pressure inside the cabinet. 

The bobbin needs to be totally sealed and the open design of the fixed ‘bullet’ approach, effective in midrange-only applications, becomes less viable. A standard dust cap will seal off the bobbin as well, but, unlike the solid construction of the plug, its membrane structure does not damp resonances on the cone itself. 

The resulting driver, with its smoother response, is more suited to the low roll-off rate that results from minimal component crossover designs. 

Copyright © 2018 Bowers & Wilkins. All rights reserved.